Toshiba Universal TV Remote Control

Model NO.
LGT-RML890
Voltage
12V
Material
ABS
Battery Type
AAA Battery
Trademark
LGT
Transport Package
Carton
Specification
200
Origin
China
HS Code
8529909090
We believe in: Innovation is our soul and spirit. Quality is our life. Shopper need is our God for Toshiba Universal TV Remote Control, The product will supply to all over the world, such as: Estonia, Dubai, Somalia, Our company, is always regarding quality as company' s foundation, seeking for development via high degree of credibility , abiding by iso9000 quality management standard strictly , creating top-ranking company by spirit of progress-marking honesty and optimism.
Guangzhou Long Gui Technology Co., Limited Diamond / Audited Supplier

This product is a self-developed product.  It is specially designed for all series of TV remote controllers of TOSHIBA at home and abroad. It is not required to be set up, but it can be used immediately with batteries installed!

Performance specification:
1 , effective distance and directivity test:
When testing within valid distances, the use of the supplied receiver does not allow any nonstandard operation.
1.1 partial angle theta = 5 DEG (,, left, right) to launch effective distance should be greater than or equal to 8.0M.
The 1.2 level is in the angle theta =45 degrees (left, right) to launch effective distance of more than 6.0M.
1.3, the vertical angle of the oblique angle at theta =30 degrees (up, down).
2. Infrared peak irradiance of remote controller:
In the natural light or fluorescent lamp 200 + 50lx environment illumination, the remote controller uses the power supply voltage under the rated operating voltage condition, in the remote control launching point
With the peak level of light illumination instrument by vertical axis distance 0.5M, press the remote control button, the infrared emission peak irradiance should not be less than 40uW/c square meter
2.1 directivity (working voltage 3.0V):
The remote control of the red light emission peak irradiance is 20uW/c square meters, with the remote launch point for the vertex angle should not be less than 30 degrees.
2.2 the directivity of the remote controller under undervoltage conditions (operating voltage 2.25V):
Infrared remote control peak irradiance is 10uW/c square meters, with the remote launch point for the vertex angle of not less than 30 degrees.
3. Environmental testing:
3.1 high temperature storage test:
Remote control in the temperature of 55 degrees Celsius environment, after the use of 2h, restore 2h, should meet the requirements, no abnormal work.
3.2 constant damp heat test:
Remote control in the temperature of 40 degrees, relative humidity of 93% in the environment, after the use of 96h, after the restoration of 4h, should be all normal.
3.3 low temperature storage test:
Remote control in the temperature of -25 degrees when the environment, after the use of 2h, restore 2h, should be all normal.
3.4 temperature change test
The remote control should be able to withstand the temperature cycle test shown in the following diagram. After 6 cycles of testing, everything should be normal.
4 , free fall test
The remote controller is free of charge in the condition of battery loading. It falls freely from 80Cm height to no more than 3Cm thick wooden floor.
Test, according to the test surface shown below, according to the order of 3-2-4-5-6-1 fall, cycle three times.
After the test, the remote control should not be cracked, the battery cover does not fall off and so on, all button functions should be normal.
5, waveform
6 , scanning vibration test
The remote control shall be able to withstand the vibration test as specified in the following table. After the test, the remote control shall be in normal condition.
Frequency range (Hz)
Displacement amplitude (mm)
Scan cycle times
Requirement
10~30 to 10
Zero point seven five
Five
Vibration on the vertical axis of the work surface
30~55 to 30
Zero point one five
6 , scanning vibration test
The remote control shall be able to withstand the vibration test as specified in the following table. After the test, the remote control shall be in normal condition.

A large number of OEM customized products are accepted and produced according to customers requirements without any design fees.

Universal air conditioner remote controller

This product is specially developed and produced by our company for export (no copyright involved, no patent), and is exported to 5 continents.

Product weight: 69g (including package)

Individual products include: remote controller packaged in transparent environmental protection bag+all-English instructions+carton packaging

40 remote controls = a small box 6 small box remote controls = a large box

Therefore, if your purchase quantity exceeds 40, youd better choose an integer of 40

 

frequency range
Hz
Displacement amplitude
mm
Scan cycle times Requirement
10-30-10 0.75 5 Vibration on the vertical axis of the work surface
30-55-30 0.15 5 Vibration on the vertical axis of the work surface