Single Cable Burning Tester Wire Vertical Flame Spread Testing Equipment is themost widely used and low cost of cable fire performance test equipment; Single Cable Burning Tester Wire Vertical Flame Spread Testing Equipment meet the national standard GB /T18380.11-2008 / IEC60332-1-1: 2004 requiremen.
Single Cable Burning Tester Wire Vertical Flame Spread Testing Equipment is to test cable , flameretardant insulation layer under fire conditions applicable for testing wireand cable in overheating, overcurrent and other non-normal state.
Single Cable Burning Tester Wire Vertical Flame Spread Testing Equipment can beused in vertical or fiber optic wire and cable flame spread test, while testunder fire conditions Dettol matter combustion conditions.
1, The touch screen intelligent control system; English user interface;
2, The system automatic ignition, automatic timing, automatic datastorage;
3, The test section and the control section is conbined design in onebox for operation;
4, Stainless steel test box, the internal cavity size: height 1200mm,width 300mm, depth of 450mm;
6, A pre-mixed burner, an inner diameter of ¢ 12 ± 0.5mm, length is 100mm. 1KW hybrid standard burner,which provides accurate test fire source;
7, The flame burning applied time and hold time can range from 0 to 99 minutes99 seconds range adjustment. Automatic control of the testing process;
8, Import needle vavle precisely adjust the flame height, according tostandards, thef blue flame height is 50mm ~ 60mm, total height 170mm ~ 190mm;
9, The gas flow rate is controlled by needle valve;
10, Equipped with a steeless flame height caliper.
|Product name||Single Cable Burning Tester Wire Vertical Flame Spread Testing Equipment|
|Power||AC220 V +/- 10V 50HZ;|
|Gas purity||Propane> 95%; compressed air|